Try it!

Setup (Trucks and Drivers)

Before starting to use the Load Planning module, Trucks and Drivers must be set. These two screens are used to create the Trucks and Drivers.

Load Planning Board

The Load Planning Board is used throughout the picking process to review the status of the pick slips assigned to each route. Dispatch Controllers will use this board to pre-plan truck loads based on the masses of the pick slips.

Move Invoice to New Route

This screen allows a Dispatch Controller to change the default pick slip (order) route to a different route if required.

Truck Loading

This is the PC screen to load pick slips (orders) into the truck. There is an HTML5 screen for a mobile device, which is better suited for this purpose. However, it can be done on the PC screen as well.

Image Removed

The HTML5 Truck Loading screen is used to load the orders into a truck.

Truck Unload

This is the PC screen for unloading returned pick slips (orders) from the truck. Although a mobile device's HTML5 screen is better suited for this purpose, it can also be done on a PC screen.

Image Removed

The HTML5 Truck Unload screen is used to unload undelivered orders from a truck.

Manual Link Pick Slip to Invoice

Occasionally, a pick slip must be manually invoiced in SYSPRO, resulting in a linkage break between the pick slip number in DATASCOPE PREMIUM WMS and the SYSPRO invoice number. The Manual Link Pick Slip to Invoice module can then manually link the SYSPRO invoice number to the DATASCOPE PREMIUM WMS pick slip so that the Load Planning Board will update correctly.

Image Removed

Reprinting

The Trip Sheet is the actual list of all orders that will accompany the Truck driver on the Route while delivering the orders.  The Trip Sheet can be reprinted if required.

Reports

Daily Trip Sheet

Image Removed

Trip Sheet Analysis

Image Removed