DATASCOPE WMS Settings to be configured (SYSPRO)

Owned by DATASCOPE WMS, created
Last updated: Aug 11, 2023
1 min read

System Settings

If you would like only SYSPRO to manage the kit issues; then the following DATASCOPE WMS setting must be configured.

If you don’t like reading, you can watch the video.

DATASCOPE Premium - WIP Kit Issues

001_Premium_WIP_KIT_ISSUE_wip_UG - v0.1.pdf

Try it!

KIT_ISSUE_MATERIAL

  • Open DATASCOPE WMS

  • Open the System Settings under Settings on the Ribbon Bar

  • Locate the JOBRECEIVING System Name

  • Search for the KIT_ISSUE_MATERIAL and change the SettingValue to SYSPRO ONLY

Set the SettingValue to SYSPRO ONLY

  • Select Apply in the bottom right corner to save the change.

KIT_ISSUE_CHECK_REQUIRED

  • Open DATASCOPE WMS

  • Open the System Settings under Settings on the Ribbon Bar

  • Locate the JOBRECEIVING System Name

  • Search for the KIT_ISSUE_CHECK_REQUIRED and change the SettingValue to N(o)

Set the SettingValue to No

  • Select Apply in the bottom right corner to save the change.

  • If this setting is not set to N(o), the system will not Kit Issue anything if there was at least one kit issue already performed in SYSPRO.